 |
 |
 |
|
This is the .28 cu in Picco Engine with Pull Start from Ofna.
This engine is used to power 1/8 scale R/C kits.
FEATURES: Black anodized .28 cu in size crankcase fits nearly every vehicle that uses a .21 size engine ABC construction (Aluminum piston with a Chromed Brass cylinder) Round Rear exhaust Ball bearing-supported heavy duty 14mm crankshaft Slide valve two needle carburetor for greater response at the beginning and end of the power band. This works well for on-road and racing applications for fast take-offs and high speed. 8mm venturi insert included, giving a good balance between power and fuel economy SG (pilot) shaft Blue anodized aluminum head 9 port sleeve
INCLUDES: One .28 Ofna Engine w/Slide Valve Carburetor and 8mm venturi One brass collet (to hold flywheel in place) One silicone rubber insert for Force and Novarossi type manifolds One running and parts information sheets One Picco Sticker sheet
SPECS: Displacement: .28 cubic inches (4.66cc) Bore: 18.35mm Stroke: 17.60mm HP: 2.9 Weight: 11.78oz (330g) Length: 80mm (3.14") front of front bearing to back of pull start Width: 31mm (1.21") width neglecting the mounting flanges 21mm (.83") width between mounting holes same side 36.5mm (1.4") width between mounting holes opposite side 31mm (1.2") crankcase width Height: 109mm (4.3") from bottom of crankcase to top of cylinder head (contact Ofna for more technical information). Needle settings: low:10½-11½ turns out / high: 3-3½ turns out
REQUIRES: Fuel with 5%-30% Nitromethane (20% is recommended) and a lubricant content of 18% or more Muffler or tuned pipe depending on application Glow plug: OFNG5107 Air Filter: OFNG1137 |
|
|
|
|
|
 |
|
 |
|
Features
- FEATURES: Black anodized .28 cu in size crankcase fits nearly every vehicle that uses a .21 size engine ABC construction (Aluminum piston with a Chromed Brass cylinder) Round Rear exhaust Ball bearing-supported heavy duty 14mm crankshaft Slide valve two needle carburetor for greater response at the beginning and end of the power band. This works well for on-road and racing applications for fast take-offs and high speed. 8mm venturi insert included, giving a good balance between power and fuel economy SG (pilot) shaft Blue anodized aluminum head 9 port sleeve
|
|
|
 |
|
 |
|
|
|
